Get Started
2534

Q: To enable OSPFv3, which of the following would you use?

  • 1
    Router1 (config - if) # ipv6 ospf 10 area 0.0.0.0
  • 2
    Router1 (config - if) # ipv6 router rip 1
  • 3
    Router1 (config - if) # ipv6 router eigrp 10
  • 4
    Router1 (config - if) # ospf ipv6 10 area 0
  • Show Answer
  • Workspace

Answer : 1. "Router1 (config - if) # ipv6 ospf 10 area 0.0.0.0"
Explanation :

Answer: A) Router1 (config - if) # ipv6 ospf 10 area 0.0.0.0 Explanation: To enable OSPFv3, you enable the protocol at the interface level as with RIPng. The command string is ipv6 ospf proces-id area area-id.

Previous Next

The Most Comprehensive Exam Preparation Platform

Get the Examsbook Prep App Today