Join ExamsbookAnswer : 4. "Switch (config-if) #switchport trunk encapsulation dot1q"
Which command will configure a switch port to use the IEEE standard method of inserting VLAN membership information into Ethernet frames?5
Q: Which command will configure a switch port to use the IEEE standard method of inserting VLAN membership information into Ethernet frames?
- 1Switch (config) #switchport trunk encapsulation ietffalse
- 2Switch (config) #switchport trunk encapsulation dot1qfalse
- 3Switch (config-if) #switchport trunk encapsulation ietffalse
- 4Switch (config-if) #switchport trunk encapsulation dot1qtrue
- Show AnswerHide Answer
- Workspace
Answer : 4. "Switch (config-if) #switchport trunk encapsulation dot1q"
Explanation :
Answer: D) Switch (config-if) #switchport trunk encapsulation dot1q Explanation: If you are on a 2950 switch, then the interface command is just swichport mode trunk since the 2050 can only run the IEEE 802.1q version. However, a 3550 can run both ISL and 802.1q, so you must also use the encapsulation command. The argument to choose 802.1q for a trunking protocol is dot1q.
Similar Questions
Since Nithya and Suganya exchange places, so Rita’s new position is the same as Monika’s earlier position. This position is 17th from the right and 10th from the left. Therefore Number of girls in the row = (16 + 1 + 9) = 26.